Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Safe to change Transmission Fluid
  FAQ FAQ  Forum Search   Register Register  Login Login

Safe to change Transmission Fluid

 Post Reply Post Reply   
Author
Whitefish1989 View Drop Down
Newbie
Newbie


Joined: June-14-2023
Location: MN
Status: Offline
Points: 15
Post Options Post Options   Thanks (0) Thanks(0)   Quote Whitefish1989 Quote  Post ReplyReply Direct Link To This Post Topic: Safe to change Transmission Fluid
    Posted: July-16-2023 at 12:57pm
Pulled a 1989 Ski Nautique out of a 5 yr storage and have been cautiously trying to ease it into service.  Pumped out  and replaced all the gas, changed the oil, replaced the cooling impeller (See my other post about cooling system troubleshooting).  Seems to be running OK.  Now I am starting to think about the transmission fluid.  I have no idea when it was last changed.  It certainly is over 5 years old and could well be 10-20 years old.  The boat only has about 500 hrs on it so total run time is probably not an issue (fluids are good for 100,000 miles in a car) but just straight age could.be.   I am all set to pump it out and replace it as the cost is cheap but then I stumble onto a post about how many problems can occur after a change as the gunk/lacquer in the system gets dislocated and clogs up the system especially if you are not changing it regularly.    Boat runs fine.  I don't want to make more problems than I solve.  Thoughts?  

Is there a way to test the fluid?  The color and clarity looks good.  
Does it really deteriorate much just with age?  I am a long way from the natural run-time limit and may never hit it
Is there a compromise - I have seen suggestions to just replace half of it every year assuming you are easing into it 
I have also seen suggestions about performing your own flush by doing two full changes in a row separated by minimal run time - this seems logical but I'd hate to mess up the process (not get all the fluid out etc) as I would be doing it for the first time



Back to Top
Jonny Quest View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: August-20-2013
Location: Utah--via Texas
Status: Offline
Points: 2979
Post Options Post Options   Thanks (0) Thanks(0)   Quote Jonny Quest Quote  Post ReplyReply Direct Link To This Post Posted: July-16-2023 at 4:23pm
Change the fluid. I like Valvoline Max multi-vehicle synthetic (gasp!).  Easy.  Don’t look back.  

JQ
Current
2003 Ski Nautique 206 Limited

Previous
2001 Ski Nautique Open Bow
1994 Ski Nautique Open Bow

Aqua skiing, ergo sum
Back to Top
KENO View Drop Down
Grand Poobah
Grand Poobah


Joined: June-06-2004
Location: United States
Status: Offline
Points: 11116
Post Options Post Options   Thanks (0) Thanks(0)   Quote KENO Quote  Post ReplyReply Direct Link To This Post Posted: July-16-2023 at 7:23pm
Since you have an 89 which was the first year of the 1.23 to 1 transmission, do you have Red ATF in there or brownish engine oil

In the early years of that transmission, PCM couldn't make up their minds about which to use and they were each recommended at different times, till they settled on ATF (Dexron 3 or an equivalent) 

Dino or synthetic discussions never have a definite answer. Both work, but PCM recommended dino

Changing half of the oil would be like changing half of your engine oil, every other spark plug, wiping half of your butt, brushing half of your teeth etc Wink

And what are good numbers or change intervals for a car really mean nothing in a boat.

Some people change their fluid every 50 hrs, some every year, some go years and years. PCM says every year

And.............how are you gonna get the old oil out? More than one person around here has used a plastic suction tube and broken it off or got it stuck in the transmission. Sometimes they got lucky and fished it out.........some had to take the transmission apart enough to get the tube out. There's a tiny hole inside to get the tube through so you can get all the oil out.

You don't wanna be that guy Wink

Plastic is a no no


Back to Top
uncle-buck View Drop Down
Senior Member
Senior Member


Joined: June-14-2004
Location: United States
Status: Offline
Points: 327
Post Options Post Options   Thanks (0) Thanks(0)   Quote uncle-buck Quote  Post ReplyReply Direct Link To This Post Posted: July-21-2023 at 9:44am
I use a vacuum type oil extractor with thin copper HVAC tubing to evacuate the used fluid. Work it gently and carefully into the trans. housing through the dipstick port. 
1990 Ski Nautique (original owner)
PCM 351W with D.U.I.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC