Velvet Drive oil cooler fittings |
Post Reply ![]() |
Author | |
NeilMcG ![]() Senior Member ![]() Joined: September-20-2021 Location: Pittsburgh, PA Status: Offline Points: 228 |
![]() ![]() ![]() ![]() ![]() Posted: July-03-2024 at 5:13pm |
Old velvet drive 1:1 71C
On the lower part there is a dual threaded bushing that houses the elbow for the hose. Does anyone know the specs on this bushing and the elbow? Are they common pipe hardware or bespoke to this tranny? . |
|
![]() |
|
KENO ![]() Grand Poobah ![]() Joined: June-06-2004 Location: United States Status: Offline Points: 11015 |
![]() ![]() ![]() ![]() ![]() |
Here's a picture showing the hose, the elbow, the bushing and the oil strainer. The bushing part number from Borg Warner is 4885B and it ain't exactly cheap. The elbow is 3/8 male NPT on one end and 1/2 inch flare fitting on the other. Borg Warner part number is 122611 or a good hardware store/auto parts store should have one. |
|
![]() |
|
NeilMcG ![]() Senior Member ![]() Joined: September-20-2021 Location: Pittsburgh, PA Status: Offline Points: 228 |
![]() ![]() ![]() ![]() ![]() |
Thanks Ken. Odd thing is there was only the tub on the left (screwed into the dry seal.) There was no screen nor the tube shown on the right. I never touched it until now, so maybe I can fish it out with a pick (assuming it's actually there.)
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |