Squirly when coming off plane |
Post Reply |
Author | |
brumby
Newbie Joined: June-06-2012 Location: NorCal Status: Offline Points: 2 |
Post Options
Thanks(0)
Posted: June-11-2012 at 5:16am |
I'm new to Wakeboarding boats. We just bought a 2008 Super Air Nautique 210. The boat is awesome! However there is one concern, the boat is a little squirly when coming off plane. I've never owned anything other than an I/O prior to this boat and I've been told there is going to be a learning curve but is it normal for the boat to try to turn abruptly to port when coming off plane?
|
|
honorificabilitudinitatibus
|
|
SNobsessed
Grand Poobah Joined: October-21-2007 Location: IA Status: Offline Points: 7102 |
Post Options
Thanks(0)
|
No, I would say that is not normal. Do you have any play in the steering? Maybe you rudder is bent.
|
|
“Beer is proof that God loves us and wants us to be happy.”
Ben Franklin |
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
Kevin,
I notice you aren't getting much action on your question. I totally agree with Chris on this one - check for slack in the steering system fore to aft. However, I must ask, does the abrupt direction change coming "off" plane (slowing down) or coming "on" plane (speeding up)?? Ether way, it still may be slack in the system that needs attending to. Also,check to see how your trim tab is set on the rudder. If set too aggressive, it could be a problem too. Lot's happens when a hull comes out of or back into the water. Damn, I hope you haven't already gotten an answer over at that other damn site PN!!!! |
|
baitkiller
Platinum Member Joined: October-11-2011 Location: SW Florida Status: Offline Points: 1693 |
Post Options
Thanks(0)
|
Kevin, please check your bilge pump is working correctly and that your shaft and rudder logs are not leaking too much. A few inches of water in the bilge when you cut the throttle will make the boat bow-steer and head dive.
|
|
Jesus was a bare-footer.............
|
|
SN206
Grand Poobah Joined: February-25-2009 Location: Fort Worth, TX Status: Offline Points: 2339 |
Post Options
Thanks(0)
|
Uneven ballast?
|
|
...those who have fallen and those who will.
|
|
mdvalant
Grand Poobah Joined: May-06-2009 Location: Bellevue, IA Status: Offline Points: 2059 |
Post Options
Thanks(0)
|
Loaded rudder?
|
|
quinner
Grand Poobah Joined: October-12-2005 Location: Unknown Status: Offline Points: 5828 |
Post Options
Thanks(0)
|
Most likely the tunable rudder needs to be adjusted. There is a section of your rudder which is adjustable or "tunable", loosen the screw and make slight adjustments then test drive. If pulling to port the movable section most likely will need to be adjusted in that same direction.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |