Parts needed for a 1978 C.C. MARTINIQUE

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   27-A rudder ,  tiller arm / rudder arm for a 27-A rudder with all nuts bolts and screws ,  front bench seat for a pattern  , rear seat top and bottom for a pattern , flat fiberglass that goes behind the rear seat ,ski pole with all hardware , 351 Commander manifolds with elbows ,raw water pump with all brackets nuts bolts and screws for a 351 Commander , wood board that screws into the rear stringers and the  fuel tank sits on top of it for a pattern . This is the board that the fuel tank screws into on both sides .............. I bought a boat that had been parted out . This one needs to be put back on the water again .It is solid and original ................ All the above parts fit a 1978 Correct Craft Martinique with a 351 Commander. If you have any of the following please email me with your photos , and price shipped to ABC Discount Towing & Recovery Inc, 4737 Smithboro Loop , Mullins S.C. 29574 . abctowing29574@bellsouth.net    Thanks Keith 843-464-0616 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Towbosssupreme Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Senior Member Joined: August-28-2009 Location: Mullins S.C. Status: Offline Points: 102	Post Options Post Reply Quote Towbosssupreme Report Post Thanks(0) Quote Reply Topic: Parts needed for a 1978 C.C. MARTINIQUE Posted: February-07-2013 at 1:19pm
	27-A rudder , tiller arm / rudder arm for a 27-A rudder with all nuts bolts and screws , front bench seat for a pattern , rear seat top and bottom for a pattern , flat fiberglass that goes behind the rear seat ,ski pole with all hardware , 351 Commander manifolds with elbows ,raw water pump with all brackets nuts bolts and screws for a 351 Commander , wood board that screws into the rear stringers and the fuel tank sits on top of it for a pattern . This is the board that the fuel tank screws into on both sides .............. I bought a boat that had been parted out . This one needs to be put back on the water again .It is solid and original ................ All the above parts fit a 1978 Correct Craft Martinique with a 351 Commander. If you have any of the following please email me with your photos , and price shipped to ABC Discount Towing & Recovery Inc, 4737 Smithboro Loop , Mullins S.C. 29574 . abctowing29574@bellsouth.net Thanks Keith 843-464-0616
	Tow Boss Supreme 71 Separator(sold) 70 Barracuda ,80 S.N ,88 Barefoot Nautique 78 American Skier 78 Martinique 77 Fish.N 67 Skylark 69 Baracuda 70 S.N. 73 Mustang,65 Century Coronado H.T 70 Century Corona

TRBenj Members Profile Send Private Message Find Members Posts Add to Buddy List Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21184	Post Options Post Reply Quote TRBenj Report Post Thanks(0) Quote Reply Posted: February-07-2013 at 2:33pm
	Email sent... pretty sure you need an 11A rudder for a Martinique. 27A was used on the Mustang/Skier/Tique and had a 1" shaft instead of the 1-1/4" you probably need.

Parts needed for a 1978 C.C. MARTINIQUE

About CCF

Donate

Partners

Contact