Boats For Sale:
New strut bushing(s) |
Post Reply 
|
| Author | |
MourningWood 
Gold Member 
Joined: June-13-2014 Location: NorCal Status: Offline Points: 918 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: New strut bushing(s)Posted: January-09-2022 at 11:04pm |
|
Out with the old, in with a 2-piece bushing?
I assume the go at either end, each lining up with one of the 2 set screws? Is this better than the one-piece that came out? Thanks
|
|
|
1964 Dunphy X-55 "One 'N Dun"
'I measured twice, cut three times, and it's still too short!" |
|
 |
|
|
Jonny Quest
Grand Poobah 
Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2995 |
Post Options
Thanks(0)
Quote Reply
Posted: January-10-2022 at 10:22am |
|
Ford vs Chevy. 2 piece or 1 piece. I did the 1 piece Johnson Duramax Cutless bearing. Six inch. I believe it was the BADE bearing.
JQ
|
|
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
|
|
|
MourningWood
Gold Member
Joined: June-13-2014 Location: NorCal Status: Offline Points: 918 |
Post Options
Thanks(0)
Quote Reply
Posted: January-10-2022 at 3:26pm |
|
Got it, thanks...
IPA or Belgian Wheat....
|
|
|
1964 Dunphy X-55 "One 'N Dun"
'I measured twice, cut three times, and it's still too short!" |
|
|
|
|
Jonny Quest
Grand Poobah
Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2995 |
Post Options
Thanks(0)
Quote Reply
Posted: January-10-2022 at 5:32pm |
Dude…I’m in Utah. Gotta be Heineken 0.0
|
|
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
|
|
|
MrMcD
Grand Poobah
Joined: January-28-2014 Location: Folsom, CA Status: Offline Points: 3764 |
Post Options
Thanks(0)
Quote Reply
Posted: January-11-2022 at 1:12pm |
|
I went with the new style plastic or Delryn? bushing. Installed easy, has near zero drag and has worked well. I only have 100 hours on it so far but happy so far. I think the plastic is the same stuff they use in Hip Joints and in automotive they use it in some tie rods and ball joints so it is pretty tough stuff. The factory stuff lasted over 1000 hours and has a track record so you are back to Ford vs Chevy.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
MourningWood wrote: