Possible purchase, looking for pointers |
Post Reply |
Author | |
Johnboy4444
Newbie Joined: July-22-2024 Location: Indiana Status: Offline Points: 3 |
Post Options
Thanks(0)
Posted: July-22-2024 at 2:13pm |
Hi, new around here. Decided to make a post and ask for some sage advice. Going later this week to look at a 78 Southwind 18 with a 351W. Price seems a tad low, but boat isn't what you'd call the "best kept" and most stellar example ever. Owner says nothing wrong with it, water ready, with the exception of some water in the oil. The seats are a bit faded and carpet could be better. But from pics it looks overall solid.
When asked more detail on the engine, the oil level is not high, just milkshaked. Claims it was his late family member's boat, and he discovered the shake while test running it to get ready for sale. Said he ran while hooked to garden hose and it fires right up and runs and idles fine. I have been around cars my whole life, so a bit of milkshake doesn't really scare me too much for the price. Figure I'll start with fresh oil change and see what comes of it. Any advice there would be appreciated, but my main question is for guidance on the "what to look fors" on these guys. Most of my experience has been with bass boats and pontoons. This is a low cost adventure and feeler for what these boats are really like to live with overall. Won't break my bank to say goodbye if need be. Any advice is appreciated in advance! |
|
67 ski nat
Platinum Member Joined: July-19-2018 Location: Santa rosa Status: Offline Points: 1194 |
Post Options
Thanks(0)
|
Try to find and buy the nicest boat you can afford happier later
Do not buy just because it’s there I typically assume milkshake means new or Rebiuld engine Do you need and enjoy mechanical projects. Channeling my inner grandpa Good luck if you get it. Pictures |
|
MourningWood
Gold Member Joined: June-13-2014 Location: NorCal Status: Offline Points: 917 |
Post Options
Thanks(0)
|
I think I would ask the seller to change the oil and filter, run it a bit and then see.....
|
|
1964 Dunphy X-55 "One 'N Dun"
'I measured twice, cut three times, and it's still too short!" |
|
wayoutthere
Senior Member Joined: February-28-2020 Location: Florida Status: Offline Points: 484 |
Post Options
Thanks(0)
|
Oh hell i hate being bobby buzzkill but you being up north, milkshake means (maybe) someone didn't winterize it correctly and (maybe) either the block or exhaust manifolds could be cracked.
Question, Hull and deck are undamaged Windshield is intact Sitting on a good solid trailer Running gear intact and appears undamaged, spin the prop and shaft doesn't bind, etc all cables move freely and so on. Tows to the ramp and test drives ok Is less than a thousand bucks and you can drive there see it, test it and tow it home in 4-5 hours Are you are tooled up for and you lay awake at night foaming at the mouth in anticipation of fiberglass and mechanical projects that take a year or two of full time work and devotion. If you answer NO to any of the above questions specially the last one take 67's advice and buy the best boat you can afford, (even then in my opinion it will inevitably need God knows what) specially if anything is showing not so good because unlike the car guys, boat guys spend a grand or two in mechanical upkeep/upgrades or upholstery or stereo right before they sell it ! I got 2 boats to look at in the sub 10 thousand range and both need a good going over-thru-and rebuild, both open bow, both composite stringer boats. |
|
Mojo
Grand Poobah Joined: December-06-2006 Location: United States Status: Offline Points: 3106 |
Post Options
Thanks(0)
|
+1
|
|
05' SV211 TE
73' Martinique had:96' SNOB had:76' Nautique had 77 Tique |
|
MrMcD
Grand Poobah Joined: January-28-2014 Location: Folsom, CA Status: Offline Points: 3750 |
Post Options
Thanks(0)
|
Any boat you buy can have many issues that need repair to be a good and safe boat.
I agree, buy the best boat you can afford but still expect some repairs. I bought our 1995 Nautique with 97 total hours on it. It was perfect from front to back, not one item damages or showing wear including the trailer. Bought it in December so no water test before purchase. First water test I found heavy vibrations, then the engine went into limp mode, Red light on the dash, this is the Fuel Injected engine 351W ProBoss. Had to replace the prop shaft, prop, and straighten the strut. Couple bad sensors fixed the Limp mode issue. Several other minor parts had failed because it sat in a garage for 20 years before I bought it. I would still have purchased the boat even if I knew about these issues because it was in such good shape and looked brand new, but I enjoy doing mechanical repairs and really liked this boat so no complaints just a warning to buy with your eyes wide open. Who would have expected this damage with 97 total hours on the boat?
|
|
Johnboy4444
Newbie Joined: July-22-2024 Location: Indiana Status: Offline Points: 3 |
Post Options
Thanks(0)
|
Thanks everyone for the input. The owner kept acting oddly and rescheduled a couple times, constantly left me on "read" when I would ask which lake to meet at for a float test. Finally I decided to tell them I would pass, the wife and I decided it was a better idea to get a boat from a local marina. We budgeted and decided we would just make a large down payment on a used boat from them.
Bit more than we initially wanted to spend, but the boat is local since new, one owner, and has been housed indoor at the marina over winter every year with records. We went and did a ride along test and the marina is being nice enough to offer us (slightly) discounted storage and winterization for being customers for as long as we own the boat, as well as a small warranty for the next month against any large undisclosed issues. Unfortunately for this forum, it isn't a Correct Craft, but a Rinker Captiva 216. 67 hours on the clock. Like new shape. Very well kept, all original covers included, no fades or cracks. Figure I'd rather make a small monthly payment for a couple years to have a much better condition boat I can actually use without TOO much worry. |
|
wayoutthere
Senior Member Joined: February-28-2020 Location: Florida Status: Offline Points: 484 |
Post Options
Thanks(0)
|
Nothing unfortunate about it, rinker is a fine boat. Congrats on the purchase !
If this is your first boat i would advise you to read the owner/operator manual. This is a good forum, plenty of help and knowledge on board. Only dumb question is the one never asked. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |