Boats For Sale:
Swim platform screws loose? |
Post Reply 
|
| Author | |
flexgris 
Newbie 
Joined: September-11-2024 Location: Montréal,Québec Status: Offline Points: 5 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Swim platform screws loose?Posted: September-23-2024 at 3:29pm |
|
Hi! I have a 90 ski nautique, love it, but the bolts on the transom on the right side that holds the platform are loose.Can I reach by the inside to the nut so I can tight it and fix that??
|
|
|
keep it simple:)
|
|
 |
|
|
KENO
Grand Poobah 
Joined: June-06-2004 Location: United States Status: Offline Points: 11212 |
Post Options
Thanks(0)
Quote Reply
Posted: September-23-2024 at 7:15pm |
|
Are these the upper or lower bolts or both upper and lower?
The upper are through bolts with nuts on the inside and the lower are lag bolts into the transom. They both go to a reinforced area with wood sandwiched between the inner and outer fiberglass. You can get to the nuts for the upper bolts with the gas tank either out or moved forward enough to give you some working room. If the lower are loose, you might have some mushy wood in there, but you could go to a bigger diameter lag bolt of the same length and see if that gives you some bite into the wood. The lower aren't through bolted because they're below the floor level.
|
|
|
|
|
flexgris
Newbie
Joined: September-11-2024 Location: Montréal,Québec Status: Offline Points: 5 |
Post Options
Thanks(0)
Quote Reply
Posted: September-24-2024 at 7:23am |
|
Ok thanks it's the upper bolts
|
|
|
keep it simple:)
|
|
|
|
|
flexgris
Newbie
Joined: September-11-2024 Location: Montréal,Québec Status: Offline Points: 5 |
Post Options
Thanks(0)
Quote Reply
Posted: September-24-2024 at 7:25am |
|
Makes sense that they are through bolts
|
|
|
keep it simple:)
|
|
|
|
|
flexgris
Newbie
Joined: September-11-2024 Location: Montréal,Québec Status: Offline Points: 5 |
Post Options
Thanks(0)
Quote Reply
Posted: October-11-2024 at 4:42pm |
|
Hi did my repair of loose platforme bolts which are lags????not through bolts ????and replaced them by ss through bolts with big washers and nuts. We don’t see the lags from the interier you have to take a layer of fiberglass off to see them
|
|
|
keep it simple:)
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options