Forums
NautiqueParts.comSpring Sale 2025
  New Posts New Posts RSS Feed - exhaust manifold leak after gasket replaced
  FAQ FAQ  Forum Search   Register Register  Login Login

exhaust manifold leak after gasket replaced

 Post Reply Post Reply   
Author
The Dude View Drop Down
Platinum Member
Platinum Member
Avatar

Joined: October-19-2004
Location: Houston
Status: Offline
Points: 1338
Post Options Post Options   Thanks (0) Thanks(0)   Quote The Dude Quote  Post ReplyReply Direct Link To This Post Topic: exhaust manifold leak after gasket replaced
    Posted: Today at 2:00pm
Mullet Free since 93

95 Sport
1978 Ski Nautique
Back to Top
The Dude View Drop Down
Platinum Member
Platinum Member
Avatar

Joined: October-19-2004
Location: Houston
Status: Offline
Points: 1338
Post Options Post Options   Thanks (0) Thanks(0)   Quote The Dude Quote  Post ReplyReply Direct Link To This Post Posted: Today at 2:04pm
Well, that was a good post.

Hi guys, I haven't been here for a while, but I still love you all!

My 95 Sport, 351 is leaking on the starboard side. I replaced the gasket. Replaced it again with RTV. still leaking...pretty badly. I'm running in brackish water, so this is especially not helpful to my engine block.

What are next steps? I thought I'd prepared both surfaces very well with block sanding, making sure to keep everything straight/even, but it's apparently not good enough. Do I need to take it somewhere to have the manifold ground down a bit and leveled? 

Skied this morning anyway. 
Mullet Free since 93

95 Sport
1978 Ski Nautique
Back to Top
KENO View Drop Down
Grand Poobah
Grand Poobah


Joined: June-06-2004
Location: United States
Status: Offline
Points: 11261
Post Options Post Options   Thanks (0) Thanks(0)   Quote KENO Quote  Post ReplyReply Direct Link To This Post Posted: Today at 7:52pm
You must be talking about the riser to manifold gasket leaking. 

If it's leaking externally, it may be leaking internally too, but you can't see that happening.

You could pull the plugs on that side and turn the engine over to see if any water comes out and also look for water on the plugs.

A  machine shop planing job on the manifold and riser would be the second best solution.

First best but pricey Wink Not knowing how many hours on run time you've had in brackish water, you might at least think a little bit about maybe getting  new manifolds and risers depending on how ugly the internal water passages look
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2025 | Bagley Productions, LLC