PCM Engine / Transmission Parts
Printed From: CorrectCraftFan.com
Category: Buy and Sell
Forum Name: Boat Parts For Sale
Forum Discription: Parts for sale only
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=1360
Printed Date: November-21-2024 at 7:33pm
Topic: PCM Engine / Transmission Parts
Posted By: Trent
Subject: PCM Engine / Transmission Parts
Date Posted: March-21-2005 at 6:58pm
I'm looking to part out my PCM out of my 1969 Mustang. The ford engine has:
-working Borg Warner 1x1 velvet-drive transmission
-rebuilt distributor
-starter that was rebuilt last summer
-good alternater
-nice holley four barrel
-new rods
-new plugs and wires
-good water pump
One of the valve covers is cracked because it rolled off the pallet as I was pulling it up an incline. The right exhaust manifold is good, but the left is shot. There was water in the oil. This was due to a busted head gasket, but the block might be cracked, I don't think so, but make no guarantees. I replaced both head gaskets but did not run the engine with the exhaust manifolds attached.
I replaced the ford 289 with a Chrysler 318 because new exhaust manifolds were more expensive than a slightly used 318 my buddy had. The engine ran when I took it out.
Also, the passenger (left) half of the windshield on my 1969 Mustang is broken. I would like to purchase the half including the aluminum edge and angle piece that attaches to the gunwale. I guess I could replace the entire thing, but I'd prefer to replace the half. Trade for engine parts?
The engine is located in the Chicago area right next to the O'hare airport. I can load it for you with my forklift or ship forward air at your cost(The forward air depot is less than a mile away.) I can also pull parts and ship UPS, Fedex, etc. to you.
I'd prefer to unload the entire engine and transmission as one, but am willing to piece it out. I can provide pics if necessary.
I'll let the whole package go for $750. The transmission alone is worth that.
-Trent
-------------
ctrentbp@yahoo.com
|
Replies:
Posted By: Guests
Date Posted: May-24-2005 at 9:17pm
|
I have an '88 barefoot nautique w/ a 454 chevy. It had a 1 to 1 velvet drive.. I need a new one though. Do you know if yours would be compatible?
|
Posted By: Guests
Date Posted: June-11-2005 at 3:05pm
HI. Are your parts still for sale? I'm local, and interested. You can email me. Thanks, Mike
mdifiore@ameritech.net
|
|