Print Page | Close Window

shifter/throttle Printed From: CorrectCraftFan.com Category: Repairs and Maintenance Forum Name: Boat Maintenance Forum Discription: Discuss maintenance of your Correct Craft URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=13878 Printed Date: November-17-2024 at 4:56pm Topic: shifter/throttle Posted By: kevin719 Subject: shifter/throttle Date Posted: June-03-2009 at 10:36pm I started my southwind today and I think that the boat upholestry shop messed it up when they removed or reinstalled it. The warm up knob does not pull out now and it is a little tough to get into reverse. Any tips on the adjustment or what to look for?Thanks ------------- kevinindy Replies: Posted By: 81nautique Date Posted: June-04-2009 at 12:32am DO you have padded coaming pads? Did they replace them? If so the bolts that hold the Morse control may need to be snugged up some as the levers may be binding on the backside. When I replaced my interior I went with a 1/2" thicker foam for the coaming pads and had a little trouble with exactly this. Just try socking those threee bolts down a little and see if that helps. ------------- You can’t change the wind but you can adjust your sails Posted By: kevin719 Date Posted: June-04-2009 at 12:38am Yes they did replace the pads. I will try to tighten the bolts and see.Thanks ------------- kevinindy Posted By: kevin719 Date Posted: June-04-2009 at 1:12am I checked it out and one of the screws on the back of the morse control was not tightened! I will try to get to it tomorrow with a 1/4 drive ratchet and socket. Is there an easy way to remove then coaming pad to acess the screws easier?? Thanks! ------------- kevinindy

Print Page | Close Window