1:1 transmisson fluid milky
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=17929
Printed Date: November-20-2024 at 4:14am
Topic: 1:1 transmisson fluid milky
Posted By: Jtandy
Subject: 1:1 transmisson fluid milky
Date Posted: June-06-2010 at 2:20pm
| Gang need advice my tranny fluid is a milky, I put in a plastic bottle and have been watching since sat morning. Appears to have a little watter on top. about 1/4 inch and the rest is still a milky color. I think I need to replace the tranny cooler. But is there any other problems that you guys have seen with this. Thanks in advance Jon |
Replies:
Posted By: 8122pbrainard
Date Posted: June-06-2010 at 2:24pm
|
Jon,
Chances are at 99% that it's your cooler. ------------- /diaries/details.asp?ID=1622" rel="nofollow - 54 Atom /diaries/details.asp?ID=2179" rel="nofollow - 77 Tique 64 X55 Dunphy Keep it original, Pete < |
Posted By: Jtandy
Date Posted: June-06-2010 at 2:26pm
| Thats kinda what I thought. but better to research than just replace parts. Thx |
Posted By: behindpropeller
Date Posted: June-06-2010 at 3:46pm
|
You can pull your cooler off and fill it with water to check it.
Tim ------------- |
Posted By: Mal
Date Posted: June-06-2010 at 4:49pm
| My 99 SN was doing exactly the same, at first i thought it was condensation as although the fluid was milky there never seemed to be an excess amount of fluid on the dipstick, I replaced the fluid 4 times, always the same after use, eventually replaced the cooler and the problem has gone. |
Posted By: 8122pbrainard
Date Posted: June-06-2010 at 5:14pm
Malcolm, Trans fluid gets out via the cooler just like water gets in via the cooler! ------------- /diaries/details.asp?ID=1622" rel="nofollow - 54 Atom /diaries/details.asp?ID=2179" rel="nofollow - 77 Tique 64 X55 Dunphy Keep it original, Pete < |
Mal wrote:Posted By: Mal
Date Posted: June-06-2010 at 6:14pm
Does the pump in the tranny pump through the cooler or suck through? just thinking that if it pumps then you would loose oil but not gain any water due to the pump pressure being greater, but if it sucks through the cooler then it would pull water in through any small holes but not neccersarily loose oil. As i said i replaced mine and all is now sweet |
Posted By: 8122pbrainard
Date Posted: June-06-2010 at 7:26pm
Pumping or sucking really doesn't matter. Keep in mind there's no suction or pressure when the engines not running. Running to sitting does produce heat/cool - expansion/contraction cycles. ------------- /diaries/details.asp?ID=1622" rel="nofollow - 54 Atom /diaries/details.asp?ID=2179" rel="nofollow - 77 Tique 64 X55 Dunphy Keep it original, Pete < |
Posted By: jbear
Date Posted: June-07-2010 at 1:12am
Are you kidding? john ------------- "Loud pipes save lives" AdamT sez "I'm Canadian and a beaver lover myself"... |
Posted By: boat dr
Date Posted: June-07-2010 at 1:50am
I hope Quinner don't see that comment''''''''''''' I get milk either way............. ------------- boat dr /diaries/details.asp?ID=4631 - 1949 Dart /diaries/details.asp?ID=1533 - 1964 American Skier |
Posted By: jbear
Date Posted: June-07-2010 at 2:07am
|
yikes..
john ------------- "Loud pipes save lives" AdamT sez "I'm Canadian and a beaver lover myself"... |