Print Page | Close Window

Transmission Leak thru shift lever input Printed From: CorrectCraftFan.com Category: General Correct Craft Discussion Forum Name: Common Questions Forum Discription: Visit here first for common questions regarding your Correct Craft URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=19803 Printed Date: April-16-2025 at 11:00am Topic: Transmission Leak thru shift lever input Posted By: Tom351 Subject: Transmission Leak thru shift lever input Date Posted: October-23-2010 at 2:57pm The transmission on my 1986 SN (351/1:1) has a decent leak through the point where the shift lever goes into the transmission case- I have never done any transmission work so this is my question? How easy/difficult is it to remove the shift lever shaft (or whatever it is called) and replace the seal at this location? Replies: Posted By: skfitz Date Posted: October-24-2010 at 8:14pm 4804H Sounds like the "O" ring that has failed. The O ring's factory part number is 4804H. You might get away with just replacing it (1/2 banana job),* but if it failed there is probably a reason for the failure, like pitting of the seal surfaces, etc. * See p. 24 of this: %20 - http://www.correctcraftfan.com/Downloads/Velvet_Service_Manual.pdf

Print Page | Close Window