'84 SN Back Seat
Printed From: CorrectCraftFan.com
Category: Buy and Sell
Forum Name: Boat Parts Wanted
Forum Discription: Parts wanted only
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=20834
Printed Date: October-31-2024 at 9:30pm
Topic: '84 SN Back Seat
Posted By: footinmuppet
Subject: '84 SN Back Seat
Date Posted: March-05-2011 at 7:05pm
|
I'm searching for a back seat for a 1984 Ski Nautique. Thanks, Mark
|
Replies:
Posted By: dwcar
Date Posted: March-05-2011 at 10:51pm
Welcome to the site Mark,
You will most likely have to fab it yourself. Do you have a picture of the seat you are after. Look thru the diaries sections and grab a picture and post it. maybe a member can get you some dimensions then.
-------------
83Ski
|
Posted By: footinmuppet
Date Posted: March-11-2011 at 12:50pm
|
Thanks for your help. I didn't even think of making one. The reference sections on this site are very useful. I'll pull the info. and try to make one. Thanks again.
|
Posted By: TimSpangler
Date Posted: March-11-2011 at 1:35pm
I am in the process of creating some drawings for the deluxe rear seat, bases seat backs and contoured corners, as well as the observers seat.
Keep an eye on the forum, once I get them done I will post them.
|
Posted By: Mile High Nautique
Date Posted: April-24-2011 at 6:43pm
I also am in need of a deluxe back seat that would fit an '89 Nautique 2001. I would be most interesteds in the drawings when/if available.
I have contacted Correct Craft a couple of times over the last two years and they were unable to provide any help. I would purchase the whole back seat to include bases, hardware, etc almost regardles of conditon. Please contact me with any pertinent information.
Thanks to all.
Denny d*ckinson
Boulder, Colorado
303-478-9420 (Cell)
-------------
Denny d*ckinson
Boulder, CO 80305
303-478-9420
|
Posted By: dochockey
Date Posted: April-24-2011 at 8:54pm
Denny do you not have a back seat?
-------------
1989 Teal Ski Nautique
1967 Mustang
Harris Float
Sunfish
|
Posted By: Mile High Nautique
Date Posted: April-25-2011 at 4:19am
I bought this '89 SN 2001 3 years ago and it never had a back seat.
The original owner used the boat only for skiing. I am seeking either a used back seat that has the appropriate mounting base, or perhaps aome specifications for fabricating one from scratch.
Thanks for your response.
Denny
-------------
Denny d*ckinson
Boulder, CO 80305
303-478-9420
|
Posted By: dochockey
Date Posted: April-25-2011 at 9:51am
My boat is currently in my dads barn, I can take some measurements and photos for you but I can't do it until later in the week, just so you know or maybe you already know, my back seat base is made out of plastic, I'm not sure if there is an after market one out there or not have not looked into it but I will.
Kirk
-------------
1989 Teal Ski Nautique
1967 Mustang
Harris Float
Sunfish
|
Posted By: dochockey
Date Posted: May-09-2011 at 11:59am
Denny sorry I took to long but just in case you still need some dimensions
My seat frames consist of three sections the main is 3' x 20 3/4" and the two sides are 11 1/4" x 20 3/4" they are 6" high. From the floor to the top of the back is 21". I will post some photos when I get home tonight
Kirk
-------------
1989 Teal Ski Nautique
1967 Mustang
Harris Float
Sunfish
|
|