Windshield Molding / Seal
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=22090
Printed Date: November-20-2024 at 12:36am
Topic: Windshield Molding / Seal
Posted By: FrankT
Subject: Windshield Molding / Seal
Date Posted: June-14-2011 at 1:33am
Finally getting the parts together for the 71 SN - thanks Tim.
I will need the rubber molding / seal that holds the glass into the aluminum frame. This is the closest product that I could find. Does anyone know if this is the correct material?
http://greatlakesskipper.com/product/5_320_352-boat-deck-and-docking-hardware-windshield-molding/19878--standard-316-inch-boat-windshield-molding-ft.html - Standard 3/16" molding
Thanks,
Frankt
|
Replies:
Posted By: TRBenj
Date Posted: June-14-2011 at 11:14am
Sorry its taken so long to get the pieces out to you Frank. Im looking forward to seeing a windshield on that red '71 though! Are you going to strip the paint off and maintain the original raw aluminum look?
Id have to measure the trim/gasket material I have, but that sure looks like the same stuff.
-------------
|
Posted By: FrankT
Date Posted: June-14-2011 at 12:17pm
Thanks Tim. At this point going to leave it black. My step pads are black and the carpet is on the darker side as well.
Frankt
|
|