exhaust thru transom
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=227
Printed Date: November-30-2024 at 11:49am
Topic: exhaust thru transom
Posted By: boatnut
Subject: exhaust thru transom
Date Posted: March-15-2004 at 3:16pm
The three inch SS pipes are cut at an angle.Would you turn them so the exterior face was verticle or so that they sloped toward the transom at the bottom?In the second case, the rubber exhaust gaurds would hang verticle which means open.
|
Replies:
Posted By: boatnut
Date Posted: March-20-2004 at 10:55am
| Never mind. I glued/glassed them in so the long edge is at the bottom and the exhaust flap will sit against the pipe when at rest. |
Posted By: tryan
Date Posted: March-20-2004 at 2:54pm
|
i would mount them so the tip is flush with the vertical plane. this will let the flappers seal the easiest. ------------- http://www.correctcraftfan.com/diaries/details.asp?ID=146&yrstart=1971&yrend=1975 - promo http://www.correctcraftfan.com/diaries/details.asp?ID=192&yrstart=1925&yrend=1970 - #2 |