1994 proboss upgrade problem
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=22811
Printed Date: November-19-2024 at 8:36pm
Topic: 1994 proboss upgrade problem
Posted By: blink
Subject: 1994 proboss upgrade problem
Date Posted: July-26-2011 at 12:44am
|
Protec crapped the bed. I purchased a new conversion kit from Jody and installed it. I have no power to the dash. Gun Driver helped me chase the wires. Everything traced, but I still have no power to the dash. I show twelve volts to the starter solenoid....that's it. Frustrated. Any suggestions are appreciated. Blink ------------- BTW looks like I lost my 82-2001 to sanity |
Replies:
Posted By: TX Foilhead
Date Posted: July-30-2011 at 12:58pm
| I remember a recent thread about the ProTec conversion and how it is actually wired and there was a picture. When I added my 2nd hot to the dash I came from the protected side of the 50 amp breaker, that was a far back as I could figure out the wiring diagram at the time. I'm not sure what all is involved with the ProTec upgrade, but I would look for something there. |
Posted By: Bri892001
Date Posted: August-01-2011 at 12:17pm
|
This was a recent thread:
http://www.correctcraftfan.com/forum/forum_posts.asp?TID=22741&title=pro-tec-up-grade - http://www.correctcraftfan.com/forum/forum_posts.asp?TID=22741&title=pro-tec-up-grade I guess if you get in touch with skidim, they have their own version of the wiring diagram that looks something like this: 
|