carb adapter
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: Common Questions
Forum Discription: Visit here first for common questions regarding your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=26269
Printed Date: December-04-2024 at 3:58am
Topic: carb adapter
Posted By: birdiebertus
Subject: carb adapter
Date Posted: June-02-2012 at 8:02pm
| i have a edelbrock performer intake manifold and a holley 4010 marine carb what carb adapter i need to make it fit. |
Replies:
Posted By: Hooty222
Date Posted: June-03-2012 at 1:49am
|
Thinking preformer manifolds can fit both square bore (holley) and spread bore(Q-jet's and holley spreads) no adapter unless PVC needs a vacuum source ------------- 1986 Ski nautique 351 1988 Barefoot nautique 454 |
Posted By: birdiebertus
Date Posted: June-03-2012 at 9:11am
oke but this is wat i have  intake manifold. this is my spacer.   if i put the spacer on my carb i have a gab and i tink it gets false air by the screwdriver.  this is my carb.  ho can help me i tink i need a adapter or so. sorry for my bad engels. |
Posted By: lewy2001
Date Posted: June-03-2012 at 9:55am
|
You need this http://www.skidim.com/prodinfo.asp?number=EDL-2732" rel="nofollow - adapter ------------- If you're going through hell, keep going http://www.correctcraftfan.com/diaries/details.asp?ID=2999" rel="nofollow - 89 Ski <a href="http://www.correctcraftfan.com/diaries/details.asp?ID=5685" ta |
Posted By: hotboat
Date Posted: June-03-2012 at 9:56am
|
Edelbrock part # 2732 ------------- Brian |
Posted By: birdiebertus
Date Posted: June-03-2012 at 9:59am
|
oke thanks do i need a open spacer olso or is it posebble to juse the wane i have. sorry for my bad engels |
Posted By: 65 'cuda
Date Posted: June-03-2012 at 11:40pm
|
The adapter is plate steel, install: gasket, plate adapter,gasket,wedge plate, gasket, carb. There is not enough surface area at the intake manifold to get a good seal with the holley pattern, the plate adapter solves this. ------------- Gary http://www.correctcraftfan.com/diaries/details.asp?ID=941" rel="nofollow - 1965 Barracuda SS |
Posted By: birdiebertus
Date Posted: June-04-2012 at 10:44am
| now i dont no what to do i tink it is first gasket,spacer,gasket,plate adapter,gasket,carb!!!! |
Posted By: hotboat
Date Posted: June-04-2012 at 12:12pm
|
Intake, gasket, edelvrock plate, gasket, your spacer with the open side down because that's what the edelvrock plate seals off, gasket, carb. B not v dang phone!!!! ------------- Brian |
Posted By: birdiebertus
Date Posted: June-04-2012 at 12:17pm
|
oke and what is then sealing of the carb? look foto 4!!! |
Posted By: hotboat
Date Posted: June-04-2012 at 12:23pm
|
Now I see, appears you would need 2 of the edelvrock plate unless you can run your spacer upside down or else eliminate your spacer and just run edel plate ------------- Brian |