3/4" push in trim
Printed From: CorrectCraftFan.com
Category: Buy and Sell
Forum Name: Boat Parts Wanted
Forum Discription: Parts wanted only
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=30012
Printed Date: November-17-2024 at 4:29pm
Topic: 3/4" push in trim
Posted By: Riley
Subject: 3/4" push in trim
Date Posted: May-28-2013 at 9:48am
Does anyone know a source for 3/4" push in aluminum trim (ribbed)? McMaster Carr only has smooth in 3/4".
http://www.mcmaster.com/#aluminum-molding/=my0z13" rel="nofollow - http://www.mcmaster.com/#aluminum-molding/=my0z13
|
Replies:
Posted By: TRBenj
Date Posted: May-28-2013 at 9:58am
Bruce, we did figure it out... Chris or Reid can dig up the link.
Original stuff is actually ~7/8" wide, the new stuff we've found is 13/16", so pretty darn close.
-------------
|
Posted By: Riley
Date Posted: May-28-2013 at 10:23am
|
I guess that leaves Chris as Reid says to ask you.
|
Posted By: Riley
Date Posted: May-28-2013 at 10:57am
Posted By: 65 'cuda
Date Posted: May-28-2013 at 11:19am
http://www.outwatercatalogs.com/lg_display.cfm/page/19/catalog/Master_2012" rel="nofollow - Lots of options
-------------
Gary
http://www.correctcraftfan.com/diaries/details.asp?ID=941" rel="nofollow - 1965 Barracuda SS
|
Posted By: storm34
Date Posted: May-28-2013 at 12:07pm
Looks like Gary's link has some more options.
Here's the http://www.tapeease.com/aluminum%20t-moldings.htm" rel="nofollow - link to the place we found. Looks like the 13/16 ALUM 1029 was the best match.
Thanks for the link above Bruce, been looking for the trim for the promo ski pockets!
-------------
|
|