Packing size
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: Common Questions
Forum Discription: Visit here first for common questions regarding your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=30022
Printed Date: November-24-2024 at 10:27pm
Topic: Packing size
Posted By: ethyl
Subject: Packing size
Date Posted: May-28-2013 at 8:28pm
|
I searched but was not able to find this basic info. I would like to know what size packing I need for the shaft log and the rudder in a 1968 Mustang with 318 Chrysler (looks like a 1 inch shaft) Thanks.
|
Replies:
Posted By: SNobsessed
Date Posted: May-28-2013 at 8:34pm
I don't know, but I can tell you how to determine correct size.
Get 3/16 & 1/4 drill bits. The one that fits between the gland & shaft will be the size you need to buy.
Correct Craft used both sizes on & off over the years.
-------------
“Beer is proof that God loves us and wants us to be happy.”
Ben Franklin
|
Posted By: ethyl
Date Posted: May-28-2013 at 8:46pm
|
Also do you know a good place to get the packing? Where are you in Iowa? I'm in Muscatine. Thanks
|
Posted By: SNobsessed
Date Posted: May-28-2013 at 9:55pm
Cedar Falls!
I got the Gore-tex packing from Ski Dim. Good People.
There are some knock offs of the Gore-tex packing, so buyer beware if you get it off the net.
How about some picts of your Mustang?
-------------
“Beer is proof that God loves us and wants us to be happy.”
Ben Franklin
|
|