Sherwood water pump 302 pcm ski tique
Printed From: CorrectCraftFan.com
Category: Buy and Sell
Forum Name: Boat Parts Wanted
Forum Discription: Parts wanted only
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=32425
Printed Date: November-17-2024 at 1:30pm
Topic: Sherwood water pump 302 pcm ski tique
Posted By: ryanibanez88
Subject: Sherwood water pump 302 pcm ski tique
Date Posted: December-06-2013 at 10:54am
I need the brass water pickup pump for my ski tique its a 1976
With 302 PCM any help would be greatly appreciated
-------------
Ryan
1997 Ski Nautique
Midland Texas
|
Replies:
Posted By: jbach
Date Posted: December-06-2013 at 12:27pm
i have a sherwood G21 pump out of a Super Air Nautique that needs a rebuild kit. it was leaking about a drip every two seconds last summer. brand new impeller in it, 0 hours. i was planning on rebuilding and selling it this winter.
i'd like $125, that would include shipping.
|
Posted By: ArtCozier
Date Posted: December-09-2013 at 3:23pm
The rebuild kits are fairly expensive, so if the housing is worn much, it's more worthwhile to buy a replacement pump. If it has leaked water, you need to replace the bearings along with the seal and seat. You need to know that getting the seal out of a G21 is tricky, because it's not practical to remove the pulley from the shaft. It is a press fit, and unless you have the exact support to put it on in the press, you will bend the pulley. To get the seal out through the impeller side, I drive a screw into the seal and pull it out with a claw-prybar. Kind of crude, but if you don't have a press and the support, it works.
-------------
"Art"
|
|