1968 Mustang ski pole ring height?
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: Common Questions
Forum Discription: Visit here first for common questions regarding your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=34502
Printed Date: November-24-2024 at 3:04pm
Topic: 1968 Mustang ski pole ring height?
Posted By: dangerwil
Subject: 1968 Mustang ski pole ring height?
Date Posted: August-25-2014 at 10:19pm
There is no telling what changes have been made to this old girl over the many years she was on the water. Can someone tell me the height of the top of the ring to the floor in an unmolested Mustang ski pole? I am setting the ski pole and I want to get it right! Thanks a million. Sorry crappy low light pic.
|
Replies:
Posted By: DrCC
Date Posted: August-25-2014 at 10:38pm
|
I would be surprised to find five '68's all with the exact same pylon height. Just turn the finger toward the dash and install. Luv the Flake!!! Ya wanna do my stripes and letters in Rally Green Flake ? |
Posted By: Gary S
Date Posted: August-25-2014 at 10:42pm
|
That pylon looks different too. How about a measurement from the gunnel to the top of the ring on a 69? ------------- http://www.correctcraftfan.com/diaries/details.asp?ID=1711&sort=&pagenum=1&yrstart=1966&yrend=1970" rel="nofollow - 69 Mustang HM SS 95 Nautique Super Sport |
Posted By: scootdogydog
Date Posted: August-25-2014 at 10:44pm
|
I just measured my 68 (ford 289), 32.5" from the top of the floor to the top of the ring. ------------- http://www.correctcraftfan.com/diaries/details.asp?ID=7183" rel="nofollow - 1999 Python 1980 Ski Tique 1968 Mustang WIP |
Posted By: OverMyHead
Date Posted: August-25-2014 at 11:02pm
I think it is. ------------- For thousands of years men have felt the irresistible urge to go to sea, and many of them died. Things got better after they invented boats. 1987 Ski Nautique |
DrCC wrote:Posted By: dangerwil
Date Posted: August-25-2014 at 11:26pm
|
I turned it around after looking at the flyer. Its going to need a spacer to fit in the later model engine frame pole clamp. I have an insane 10 foot pole the PO had made for barefooting. It might work out better cutting it down and using it. Its installed in the below pic. Thanks scootdogydog  
|
Posted By: dangerwil
Date Posted: September-17-2014 at 9:29pm
Just wanted to say thanks again for the help. Here is the new pole installed and ready to measure the floor template.
|