Print Page | Close Window

ski tique 302 Float Heights(measurements) Printed From: CorrectCraftFan.com Category: Repairs and Maintenance Forum Name: Engine Repair Forum Discription: Engine problems and solutions URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=34621 Printed Date: October-08-2024 at 6:37am Topic: ski tique 302 Float Heights(measurements) Posted By: 76 Ski Tique Subject: ski tique 302 Float Heights(measurements) Date Posted: September-12-2014 at 8:06pm hey there guys just did a carb rebuild with a holley marine renew kit. just had a question on the float heights or measurements. does anyone know from experience what the correct heights are. ------------- B.O.A.T- bust out another thousand Replies: Posted By: boardersdad Date Posted: September-12-2014 at 10:59pm Not sure if you have a 4160 but I just replaced the primary bowl on mine. The floats one both the old and "new" (used) were set so if you hold the bowl upside down, a 7/64" drill bit could barely slide along the bowl inside surface without touching the float. Not sure what is called out in a manual, though. Posted By: 76 Ski Tique Date Posted: September-13-2014 at 12:52am Thanks for the response. I do have a 4160 holley 450cfm. I spoke with holley and they said set the floats level. Put it back together runs fine but i do need get to to theyou river to check performance. ------------- B.O.A.T- bust out another thousand

Print Page | Close Window