transmisson problem
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=3595
Printed Date: November-23-2024 at 10:08am
Topic: transmisson problem
Posted By: floppy
Subject: transmisson problem
Date Posted: May-18-2006 at 7:53am
hey guys, I think i posted this topic in the wrong forum. Where the linkage goes into the transmission, There is a small leak. It seams like the only time it leaks is when the boat is in neutral and the shaft completly quits turning. Wondering if thier is a seal or O ring behind the stud that sticks out for linkage to mount on. Is this a major job? Thanks
-------------
Hey ya'll, Watch this!!!!!!!!
|
Replies:
Posted By: rmcdonald
Date Posted: May-18-2006 at 8:50am
Hi Floppy
Check out the referece section of this site. You can download the workshop manual for borgwarner velvet drives.
Regards
Rob McDonald
|
Posted By: GottaSki
Date Posted: May-18-2006 at 9:18am
O-ring. Its about as minor a job as you can get on that transmission. Check the manual as Rob suggests.
-------------
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole
|
Posted By: jimbo
Date Posted: May-18-2006 at 11:51am
It's pretty easy. I did mine a couple of weeks ago. The instructions are on p.24. There's a spring loaded ball behind the lever plate so be careful.
Order this gasket from Skidim:
http://www.skidim.com/prodinfo.asp?number=RM0011
I matched up the o-ring at the auto parts store.
|
Posted By: floppy
Date Posted: May-18-2006 at 5:36pm
thanks guys, I feel alot better now. I just redone the floor, carpet, ulpostry and had the carb rebuilt. Think i am ready to go and this happens. thanks again..........
-------------
Hey ya'll, Watch this!!!!!!!!
|
|