Shaft aligh ment
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=36420
Printed Date: November-17-2024 at 3:28am
Topic: Shaft aligh ment
Posted By: steve a
Subject: Shaft aligh ment
Date Posted: June-22-2015 at 12:36am
|
I just replace cuttless bearing installed a doubletaper shaft while I am at it I should ck the alighment to the shaft . What I got was .011 lowest read and .014 highest read on my gauges . I have heard though video on Cc fan sites it needs to be. 003 of and inch variance to have proper alighment . I believe or hope that I am right . I did ck top to bottom and side to side bottom was the hardest the get . Also with the new shaft was not able to get safety ring on doubletaper shaft I don't believe it as nessary the old shaft was press on by factory my why new shaft has locking nut attached to the shaft holding the coupling . Thanks Steve
|
Replies:
Posted By: 8122pbrainard
Date Posted: June-22-2015 at 7:09am
Steve,
Since yo got .011 and .014, that's the .003 max so you're good.
-------------
/diaries/details.asp?ID=1622" rel="nofollow -
54 Atom
/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique
64 X55 Dunphy
Keep it original, Pete
<
|
Posted By: steve a
Date Posted: June-22-2015 at 10:29pm
|
Thanks I appreciate it I ck out CCF 101 SHAFT ALIGHMENT VIDEO .I believe that what was said on video but not sure . Thanks Steve
|
|