3/4 hose from water pump to exhaust manifold
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=39582
Printed Date: November-16-2024 at 1:49pm
Topic: 3/4 hose from water pump to exhaust manifold
Posted By: KooK
Subject: 3/4 hose from water pump to exhaust manifold
Date Posted: August-03-2016 at 5:38pm
1979 Mustang 17 302 4v w/ Commander exhaust manifolds.
So just a real quick question. There are 4 hoses, all 3/4 inch ID on my exhaust manifolds and they're getting a little old and need to be replaced. Where I'm at there is no boat specific parts store so I'm limited to the auto parts store or online ordering. Does this 3/4 inch hose need to be high temp and high pressure? Does it actually carry much pressure (can I use heater core hose?)? What came off it was a Goodyear Horizon 200 hose and I can't find that anywhere near me. Just looking for some suggestions on what to put back on.
Thank you.
|
Replies:
Posted By: 8122pbrainard
Date Posted: August-03-2016 at 5:44pm
Aaron,
You're good to go at the auto supply. Just normal heater hose works. The pressure is minimal and typically only about 4 PSI
-------------
/diaries/details.asp?ID=1622" rel="nofollow -
54 Atom
/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique
64 X55 Dunphy
Keep it original, Pete
<
|
Posted By: Irydslow
Date Posted: August-05-2016 at 2:24pm
I used high-temp hose from the hardware store...worked fine so far! Just moving hot water from point A to point B.
-------------
78 Correct Craft Southwind 20
|
|