1988 Nautique Dash Panel.
Printed From: CorrectCraftFan.com
Category: Buy and Sell
Forum Name: Boat Parts For Sale
Forum Discription: Parts for sale only
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=42048
Printed Date: November-21-2024 at 2:09pm
Topic: 1988 Nautique Dash Panel.
Posted By: rgrimes007
Subject: 1988 Nautique Dash Panel.
Date Posted: October-15-2017 at 2:01pm
I have a half dozen water jet cut 1988 Ski Nautique switch panels. I had these cut from aluminum. They will need fine tuning, painting and screen printed. With this the broken center piece will be permanently eliminated.
$55 including shipping.
Richard Grimes. 205-229-5534
-------------
Richard Grimes
|
Replies:
Posted By: 8122pbrainard
Date Posted: October-15-2017 at 2:32pm
Richard,
I'm curious how you finished yours. You mention screen printing. Did you have a screen made for the graphics? How about some pictures?
-------------
/diaries/details.asp?ID=1622" rel="nofollow -
54 Atom
/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique
64 X55 Dunphy
Keep it original, Pete
<
|
Posted By: TRBenj
Date Posted: October-15-2017 at 7:55pm
|
I'd like to see the finished product as well... pics?
|
Posted By: rgrimes007
Date Posted: October-15-2017 at 8:01pm
I have done them a couple of different ways but have sold the boats that I used the in. The best look I came up with was black anodized with screen printed switch lables.... I do not have pictures or the screen. These are just raw aluminum. You would need to wet sand the face taking note to get the sanding marks all in line. ( about 320 grit) and have it anodized. I have also powder coated one and it looked good. Not as good as anodizing but was much less involved.
Email me. I cannot figure out how to post a picture to the forum on my iPad. Rgrimes@RealtySouth.com
-------------
Richard Grimes
|
|