Carb question
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=4283
Printed Date: February-17-2025 at 8:07am
Topic: Carb question
Posted By: duffnit
Subject: Carb question
Date Posted: July-26-2006 at 10:09pm
|
Holley 4160 recently rebuilt by PCM mechanic.
Noticed gas forming on the linkage (portside)where the bolt thingy that goes into the base of the carb connects the linkage. Does that make any sense? Is there a fix/repair for this? All help appreciated. Thanks d ------------- Danny "no offense- but the rate at which you spread bad information is very impressive" |
Replies:
Posted By: Tim D
Date Posted: July-27-2006 at 5:43pm
|
Are you talking about the linkage that goes to the accelerator pump? ------------- Tim D |
Posted By: duffnit
Date Posted: August-01-2006 at 8:17pm
Tim D sorry for the delay. The circled area is what I noticed gas forming on. There was a very small pool of gas directly under it on top of the manifold. Although I've only noticed it once this year, I was concerned, as this was the main reason I had the carb rebuilt. Any ideas/thoughts would be appreciated. d ------------- Danny "no offense- but the rate at which you spread bad information is very impressive" |