Torque Specs
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=42868
Printed Date: September-23-2024 at 5:48am
Topic: Torque Specs
Posted By: Wisky Badger
Subject: Torque Specs
Date Posted: May-31-2018 at 11:28pm
|
Where can I find the torque specs for exhaust manifolds and risers for 351 Windsor?
|
Replies:
Posted By: gt40KS
Date Posted: June-01-2018 at 12:02am
I don't know what era Nautique you have, but if you go to the 'reference' tab above then to the manuals tab there are several service manuals to chose from. The one from your era 351 should have the specs you need.
-------------
JCCI
1995 Ski Nautique GT40
|
Posted By: Wisky Badger
Date Posted: June-01-2018 at 12:54am
|
I found torque specs for the cylinder heads but not the exhaust manifolds or risers. It is for a 1981 era 351.
|
Posted By: KENO
Date Posted: June-01-2018 at 1:15am
Try page 187 in the manual in the link below
Pretty wide ranges
It has 18-24 ft lbs for the exhaust manifold bolts to the head and it says if something isn't listed to use the table on that page. The riser bolts are 5/16-18 and it gives 12-18 ft lbs. They're not specifically listed in the engine manual.
http://www.planetnautique.com/CorrectCraftManuals/PCMNewer.pdf" rel="nofollow - link
|
Posted By: Wisky Badger
Date Posted: June-01-2018 at 1:17am
|