Distributor replace doesn't work
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=43034
Printed Date: October-06-2024 at 2:18pm
Topic: Distributor replace doesn't work
Posted By: dougs_boat
Subject: Distributor replace doesn't work
Date Posted: June-25-2018 at 4:12pm
Hi Everyone I have a 1999 air tique 5.8 351W engine. After a long time trouble shooting an intermittent idle problem I think I found the problem, A bad bearing in the distributor shaft, it has a fair bit of play. I ordered and installed a new one from SKIDIM and I cant get the engine to fire at all. Anyone have any luck with these replacement distributors(sierra 18-5489-2)? I removed the distributor from the block and left all connections intact then I connected a spark plug to the output of the coil and it was sparking as I spun the distributor manually(I could hear them snapping and kind of see it on a sunny day). Spark plugs don't seem to be getting any spark. I put my old distributor back in to verify I am doing it correctly and after about 10 min it fired up no problem.
Any advice is really welcome. Doug at the cottage
|
Replies:
Posted By: Jonny Quest
Date Posted: June-25-2018 at 11:15pm
Give Vince at Skidim a call. He is very knowledgeable and can help you troubleshoot your distributor issue.
JQ
------------- Current 2003 Ski Nautique 206 Limited
Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow
Aqua skiing, ergo sum
|
Posted By: dougs_boat
Date Posted: June-27-2018 at 10:51am
Vince is a great guy. I had everything connected and configured correctly. I removed/bypassed the ballast resistor and the boat fired up no problem. Coil runs a bit hot, but should be fine.
Problem solved
|
Posted By: bb12
Date Posted: June-27-2018 at 10:53am
Glad you got it figured out.
------------- 1989 Ski Nautique 2001
|
Posted By: KENO
Date Posted: June-27-2018 at 12:23pm
dougs_boat wrote:
I had everything connected and configured correctly.
|
Well, not quite otherwise you would have had a running engine after the install
Did you get instructions with the distributor?
|
|