help identify parts please
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=43221
Printed Date: November-15-2024 at 5:50pm
Topic: help identify parts please
Posted By: 74Wind
Subject: help identify parts please
Date Posted: July-23-2018 at 3:51pm
|
74 351 T-E. Starts/runs well, gets a bit boggy maybe 45 minutes in, but never dies. Hasn't had much use, been running out the old gas, visually tank looks clean, but sure it's due for fuel filter, might as well ask about other potential culprits while here: Can anyone identify below fuel filter, coil and valve and advise a source, and replacement process? (or any other ideas..) Thanks      ------------- 1974 Southwind 18 1975 Century Mark II |
Replies:
Posted By: gun-driver
Date Posted: July-23-2018 at 4:19pm
|
Valve covers are after market painted blue instead of original black, I have a set I’d sell if anyone is interested. Coil is either resisted or not can check how it’s wired through the ballast resistor or use a meter. Can’t help ya on the filter. |
Posted By: Gary S
Date Posted: July-23-2018 at 5:34pm
|
Filter you remove by turning counter clockwise it has an replaceable element inside, don’t damage the housing, you can still get them but not easy. You can use a Fram CG 20 or whatever brand you like that cross references. Make sure there is a new gasket in the box when you purchase it. GF 157 in AC filters ------------- http://www.correctcraftfan.com/diaries/details.asp?ID=1711&sort=&pagenum=1&yrstart=1966&yrend=1970" rel="nofollow - 69 Mustang HM SS 95 Nautique Super Sport |
Posted By: gun-driver
Date Posted: July-24-2018 at 9:45pm
|
OOPS sorry thought you meant valve covers but I see you mean the anti-syphon valve assuming the one with the braided fuel line, looks like it could be this https://www.skidim.com/ELBOW-3_8-INV-FLARE-X-1_4-NPT/productinfo/R024017/" rel="nofollow - https://www.skidim.com/ELBOW-3_8-INV-FLARE-X-1_4-NPT/productinfo/R024017/ The straight one I would think is your vent and would just be a barb fitting for 5/8 vent tubing |