Print Page | Close Window

Might Have a Problem Printed From: CorrectCraftFan.com Category: Repairs and Maintenance Forum Name: Boat Maintenance Forum Discription: Discuss maintenance of your Correct Craft URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=4886 Printed Date: January-17-2025 at 1:35am Topic: Might Have a Problem Posted By: 1998Nautique Subject: Might Have a Problem Date Posted: September-29-2006 at 9:13am Here is what I did. I drained all the water out of my block, and I unhooked the hose by the inlet on the botttom of the boat and I ran Antifreeze through the motor until it came out the back. The sea strainer was full when I shut it off. I went and looked today and the strainer was just about empty. Does some antifreeze run out of it? Thank x Replies: Posted By: marks Date Posted: October-01-2006 at 10:19pm Since the water inlet is lower than the sea strainer, its reasonable that it could siphon out. However, it is not good to leave anitfreeze in the sea strainer. It will eventually frost the clear plastic.

Print Page | Close Window