Print Page | Close Window

Ballast Pump Bypass Switch? Printed From: CorrectCraftFan.com Category: General Correct Craft Discussion Forum Name: General Discussion Forum Discription: Anything Correct Craft URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=48917 Printed Date: March-05-2025 at 1:12pm Topic: Ballast Pump Bypass Switch? Posted By: vbatla Subject: Ballast Pump Bypass Switch? Date Posted: June-22-2020 at 10:49pm Are there factory bypass switches for each ballast pump on a 2002 SANTE? I'm looking to fill the port side only. The dash switch controls all three. I know I could leave the inlet valves closed but I believe that would damage the pumps. Thanks in advance for any insight/recommendations! Replies: Posted By: DVskier Date Posted: June-22-2020 at 11:19pm planetnautique.com can answer your question. Posted By: stepper459 Date Posted: June-22-2020 at 11:47pm I kind of doubt it would really hurt the pump to run for a few minutes with the valve closed, but I can't say I've tried it. My '03 has separate switches for each pump. The tanks will probably also fill mostly just by driving around, so if you open the valve on the port side only, then drive a bit, you might just get the result you're looking for.

Print Page | Close Window