Print Page | Close Window

80's Martinique Engine Cradle

Printed From: CorrectCraftFan.com
Category: Buy and Sell
Forum Name: Boat Parts For Sale
Forum Discription: Parts for sale only
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=49193
Printed Date: November-22-2024 at 6:04am


Topic: 80's Martinique Engine Cradle
Posted By: searider
Subject: 80's Martinique Engine Cradle
Date Posted: September-06-2020 at 1:11pm
For sale. This came from a 1988 Martinique. I planned to use it on a project but ended up now needing it.

Should fit 86-88 Martinique as is and possibly other boats with modification. Measures to fit 21" inside the stringers.





-------------
Marc

http://s114.photobucket.com/albums/n269/mjconn42/Southwind20/?action=view¤t=13e61aa7.pbw" rel="nofollow - 84 Southwind



Replies:
Posted By: TRBenj
Date Posted: September-07-2020 at 7:08am
I wouldn’t expect it to fit a Bfn without modifications. Have you measured or checked the fit?

Posted By: searider
Date Posted: September-07-2020 at 3:03pm
Thanks for the correction, Tim. I changed the listing. I was going by what another member (Hollywood) said in referencing this series Martinique cradle and the BFN having the same width between stringers.

-------------
Marc

http://s114.photobucket.com/albums/n269/mjconn42/Southwind20/?action=view¤t=13e61aa7.pbw" rel="nofollow - 84 Southwind


Posted By: TRBenj
Date Posted: September-07-2020 at 3:48pm
I suspect he was referencing the 2gen MQ which was basically the Bfn hull... but just about any correct craft made prior to ‘88 is going to have the same inside stringer width. That is an industry standard as far as I can tell.

What is likely to be less consistent from model to model is the stringer and floor heights used... we know the 3gen MQ had a taller floor than the Bfn.


Print Page | Close Window