Print Page | Close Window

1983 SKI Nautique

Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=49939
Printed Date: March-04-2025 at 4:36am


Topic: 1983 SKI Nautique
Posted By: girlfriendsuncleboat
Subject: 1983 SKI Nautique
Date Posted: June-23-2021 at 3:36pm
Okay, so for starters, I was asked to work on this boat for my girlfriends elder uncle. He would like to see it in mint shape as it once was. Finally got the boat lake ready. Required a card rebuild and an ignition issue. Now, my issues are. Gas gauge not works (have a new sending unit and gauge on the way), chasing a pain in the a$$ leak (found the rubber exhaust in the rear was cracked and leaking when sitting. found this by having the boat out of the water and filling up the inside with a hose. But still have a leak). Last major issue just ran into yesterday, bilge pump no longer works. cant really use the boat until that bilge pump starts working again. Any help or advice on common leaking spots or bilge issues or even fuel gauge not working would be appreciated.SmileSmileSmile

-------------
Preston J Marx, Don't trust anything I say



Replies:
Posted By: GPJ
Date Posted: June-23-2021 at 3:53pm
Drive shaft packing seal
Speedo pickup tubes
Rudder
Exhaust

Pull the floor behind the engine cover.  You should see the water coming in past the drive shaft seal.  May only need tightening, may need new packing rope.


-------------
GPJ


Posted By: 8122pbrainard
Date Posted: June-23-2021 at 4:21pm
Fill up the bilge with water again. How's the prop shaft packing at the log? It may be dried out? 

-------------
/diaries/details.asp?ID=1622" rel="nofollow -

54 Atom

/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique

64 X55 Dunphy

Keep it original, Pete
<


Posted By: girlfriendsuncleboat
Date Posted: June-23-2021 at 4:44pm
I had just replaced it, its not coming from there, but Il give it another shot



-------------
Preston J Marx, Don't trust anything I say


Posted By: girlfriendsuncleboat
Date Posted: June-23-2021 at 4:45pm
The exhaust is no longer leaking after replacing the few parts. the pick up tubes were leaking but not anymore, the rudder i just re packed and the drive line i have not checked. that'll be next

-------------
Preston J Marx, Don't trust anything I say


Posted By: 67 ski nat
Date Posted: June-23-2021 at 10:22pm
Excellent screen name. Cool boat. Good luck



Print Page | Close Window