Velvet drive
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=49976
Printed Date: November-23-2024 at 2:53am
Topic: Velvet drive
Posted By: Tom85
Subject: Velvet drive
Date Posted: July-05-2021 at 9:40am
|
I was running across the lake yesterday with no problems and out of nowhere the boat just stopped and engine revved up. I placed shifter in neutral and tried to put it back in fwd and could hear knocking. It did not go in fwd Back to neutral and the knocking was still there. Boat will not go in any gear now. It knocks from transmission area and the output shaft moves slightly on and off while engine is running Any thoughts? |
Replies:
Posted By: 8122pbrainard
Date Posted: July-05-2021 at 9:59am
|
Tom, I'd say the trans is fine but the damper plate isn't. Pulling the bell housing and trans will confirm. Welome to CCfan. What boat is it?
------------- /diaries/details.asp?ID=1622" rel="nofollow - 54 Atom /diaries/details.asp?ID=2179" rel="nofollow - 77 Tique 64 X55 Dunphy Keep it original, Pete < |
Posted By: Tom85
Date Posted: July-05-2021 at 10:52am
| It’s in a 1986 correct craft martinique. Trans was rebuilt in 2016. |
Posted By: 8122pbrainard
Date Posted: July-05-2021 at 10:54am
Was a new damper installed when the trans was done? For around $100, it's always a good move. ------------- /diaries/details.asp?ID=1622" rel="nofollow - 54 Atom /diaries/details.asp?ID=2179" rel="nofollow - 77 Tique 64 X55 Dunphy Keep it original, Pete < |
Tom85 wrote:Posted By: Tom85
Date Posted: July-05-2021 at 11:14am
| I don’t see it on the receipt. It was done by the previous owner. But I was provided a receipt rebuild was about 2300. |
Posted By: KENO
Date Posted: July-05-2021 at 12:51pm
If you click on the link below, you'll find an old thread with pretty much everything you need to know about getting to your damper plate and replacing it.  http://www.correctcraftfan.com/forum/forum_posts.asp?TID=42615&title=damper-plate" rel="nofollow - link
|
Posted By: Tom85
Date Posted: August-08-2021 at 12:18pm
| Thanks for the help got it all fixed. Not to bad of a repair just a little labor. |