Print Page | Close Window

GT-40 Engine Decal Question

Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50088
Printed Date: March-04-2025 at 1:42am


Topic: GT-40 Engine Decal Question
Posted By: burban65
Subject: GT-40 Engine Decal Question
Date Posted: August-01-2021 at 10:01pm
I am wanting to get a new / replacement for the main red and yellow Pro Boss GT-40 decal  (larger lettering on top of motor) for my 96 Ski Nautique.  I have a local sign shop that does a great job with my boat numbers and I am sure they could easily replicate the design, font, colors etc.....off a picture but with the engine temperature and heat where that decal / lettering is I am not sure the typical vinyl lettering material they use would last under the heat or if it is even safe to use.   
I searched the internet and CCFan but did not find anything for the GT-40 decal.
I would appreciate any suggestions etc.... from the group on what options would be out there for me to get this decal or lettering bought / made.



-------------
SRB


Replies:
Posted By: JD ski
Date Posted: August-05-2021 at 12:46pm
So, are you asking for a photo of the GT-40 Pro Boss stickers? Or what type of material may be best for the hot environment and a photo. I can provide a photo. It may be a little trial and error as to the type of material to make the sticker out of. I am sure there is more heat tolerant material and your shop should have knowledge of that. There are and most engine bays motors and dog houses have stickers within and on them from the factory. You just need to install the stickers back in their original locations as I am sure you plan on and you should be safe.


-------------
JD ski, slicing, dicing, and shredding since 1981

1999 Air Nautique, GT40 Pro Boss, Trail Rite trailer
1975 Century Resorter


Print Page | Close Window