Wiring diagram 1982 Ski Nautique 351 Ford
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50133
Printed Date: November-23-2024 at 4:02am
Topic: Wiring diagram 1982 Ski Nautique 351 Ford
Posted By: morris2125
Subject: Wiring diagram 1982 Ski Nautique 351 Ford
Date Posted: August-15-2021 at 3:17pm
|
Hello
I have a 1982 Ski Nautique with the 351 Ford. I have an aftermarket alternator that has four wires. I am looking for a wiring diagram please. Any help would be greatly appreciated. Thanks Matt
|
Replies:
Posted By: 8122pbrainard
Date Posted: August-15-2021 at 3:50pm
|
Matt, This may help but it only shows 3 wires. I know Ken will be by who can really help. Post what alternator you purchased.  ------------- /diaries/details.asp?ID=1622" rel="nofollow - 54 Atom /diaries/details.asp?ID=2179" rel="nofollow - 77 Tique 64 X55 Dunphy Keep it original, Pete < |
Posted By: KENO
Date Posted: August-15-2021 at 5:23pm
Ken can probably help, but you'll have to answer Pete's question first  Is this a PCM 351 engine or maybe a Commander 351. It would also be good to know what your old alternator was and how many wires it had hooked to it. An 82 most likely had a Prestolite with an external voltage regulator unless it was replaced at some time in the past. The regulator would be on the back of the engine near the relay/solenoid for the starter and the main breaker.
|
8122pbrainard I know Ken will be by who can really help. Post what alternator you purchased. Posted By: morris2125
Date Posted: August-15-2021 at 8:30pm
|
This has a Prestolite ignition, 351 PCM Ford it looks looks a Mando alternator.AC155614 M56750
I got into this project at halftime. I do not have old alt. Probably two of the wires can be combined. Thanks again, Matt
|
Posted By: KENO
Date Posted: August-15-2021 at 8:50pm
Take a look at the Mando pictures in the thread in the link below and see if that helps. http://www.correctcraftfan.com/forum/forum_posts.asp?TID=49205&title=alternator-no-spark-help" rel="nofollow - link In the picture with short wires hooked to the alternator you'll see the following. Orange is output terminal Jumper installed between output and sensing terminal Black to Ground Yellow is excitation from 12 volt source, same power that supplies the ignition and the choke Maybe the second half will be good to you If you have an external regulator as mentioned earlier, it can be removed completely, since this Mando is internally regulated
|
Posted By: morris2125
Date Posted: August-15-2021 at 10:29pm
|
Thanks for your help. Tomorrow I will get back at the Nautique. Matt
|
Posted By: KENO
Date Posted: August-16-2021 at 6:01am
|
Not knowing if you had an external voltage regulator or not, you might have to be working from this early PCM wiring diagram for your boat. The Purple wire with the Purple arrow pointing to it going to the regulator would be used to supply alternator excitation by lengthening it to go up to the alternator. The stuff circled in Orange isn't needed any more
 |