Intake manifold gaskets
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50328
Printed Date: November-22-2024 at 11:31pm
Topic: Intake manifold gaskets
Posted By: MourningWood
Subject: Intake manifold gaskets
Date Posted: October-24-2021 at 10:29pm
|
Just taking apart PCM Ford 351W engine from '94. Found molded rubber end seals for the intake manifold. They sort of clamp-on to the rail. Never seen/used these before, but I like them. Original? Where can I get a set? Thx. ------------- 1964 Dunphy X-55 "One 'N Dun" 'I measured twice, cut three times, and it's still too short!" |
Replies:
Posted By: Jonny Quest
Date Posted: October-25-2021 at 8:46am
|
Post a pic or 2 of the gaskets in question. From your description, they don’t seem to be OEM standard gaskets. www.skidim.com and www.NautiqueParts.com have ‘em. JQ
------------- Current 2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
Posted By: KENO
Date Posted: October-25-2021 at 6:43pm
|
Doesn't do you any good, but they're easy to find in some Chevy gasket kits and some 302 Fords have them too. One possibility would be Mahle MS 15942 and another would be FelPro MS 96025.............they might have the rubber end seals.........maybe http://www.summitracing.com/parts/fel-ms96025" rel="nofollow - link
They show rubber end seals, but some packages come with a couple tubes of RTV instead of the rubber seals.  |