1982 PCM pcv hose
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50421
Printed Date: November-22-2024 at 11:03pm
Topic: 1982 PCM pcv hose
Posted By: MourningWood
Subject: 1982 PCM pcv hose
Date Posted: January-05-2022 at 4:05pm
|
The fitting on the carb spacer and the PCV valve don't match-the PCV valve being smaller. Is there a special hose for this, or just heat/stretch/force? Thanks ------------- 1964 Dunphy X-55 "One 'N Dun" 'I measured twice, cut three times, and it's still too short!" |
Replies:
Posted By: Jonny Quest
Date Posted: January-05-2022 at 5:45pm
|
Stretch. You don’t want air leaks. Nothing super special about PCV hose. JQ ------------- Current 2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
Posted By: MourningWood
Date Posted: January-05-2022 at 6:17pm
|
Thanks JQ ------------- 1964 Dunphy X-55 "One 'N Dun" 'I measured twice, cut three times, and it's still too short!" |
Posted By: KENO
Date Posted: January-05-2022 at 7:19pm
|
I think if you measure the fitting on the PCV valve you'll figure out that a 3/8 ID hose is a good fit and if you measure the fitting on the spacer, it's slightly tapered and about 9/16 of an inch. That's a lot of streeeetching for that poor 3/8 hose.  PCM had a part number for that hose. It's R045050. It comes with different ID ends. I have no idea if it's still available these days. I've used a 9/16 ID gas/oil hose that can clamp over the 9/16 fitting on the spacer and then with multiple sizes of heat shrink tubing, built up the fitting on the PCV so the hose slid over it and could be clamped on. No stretching needed
|
Posted By: Gary S
Date Posted: January-05-2022 at 8:11pm
|
Chances are it's not a PCM part anyway but in fact supplied by Ford. I had the same problem when looking for a replacement hose for my HM. Did my homework and found one here that worked- http://www.cjponyparts.com/catalogsearch/result/?q=289+pcv+hose" rel="nofollow - http://www.cjponyparts.com/catalogsearch/result/?q=289+pcv+hose ------------- http://www.correctcraftfan.com/diaries/details.asp?ID=1711&sort=&pagenum=1&yrstart=1966&yrend=1970" rel="nofollow - 69 Mustang HM SS 95 Nautique Super Sport |
Posted By: MourningWood
Date Posted: January-07-2022 at 8:29pm
|
Great. Thank you all. ------------- 1964 Dunphy X-55 "One 'N Dun" 'I measured twice, cut three times, and it's still too short!" |