Muffler installation
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: Common Questions
Forum Discription: Visit here first for common questions regarding your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50568
Printed Date: November-21-2024 at 1:45pm
Topic: Muffler installation
Posted By: Bama Scott
Subject: Muffler installation
Date Posted: April-17-2022 at 3:21pm
|
89 BFN. I noticed there is a baffle in the muffler. Does the open part of the baffle point downwards? ------------- 1989 BFN |
Replies:
Posted By: gun-driver
Date Posted: April-22-2022 at 10:44pm
| Up |
Posted By: KENO
Date Posted: April-23-2022 at 11:01am
You probably have 2 baffles, one at each end of the muffler assuming this is an in line muffler and you have 2 mufflers. It's a funny shaped baffle and the open circular part of the baffle faces down, not up. As the exhaust and water mix comes into the muffler it has to go upwards to get through the hole. If you hold the muffler up to some light, you can see light all the way through on the bottom (even with the bottom of the hole so there's a small area of the bottom where you won't see light) and just darkness on the top.. And if you have a decal on the muffler, the decal is on the top.
 |
Bama Scott wrote:Posted By: gun-driver
Date Posted: April-24-2022 at 11:45am
|
I misinterpreted the OPs question. The baffle goes up or on top and the unobstructed area is down. What I was saying is the baffle is up which after re-reading the question would be incorrect. Thanks for explaining it better for him Keno.
|