Throttle cable snapped, how to identify
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50656
Printed Date: November-22-2024 at 7:08pm
Topic: Throttle cable snapped, how to identify
Posted By: CanvasVapor
Subject: Throttle cable snapped, how to identify
Date Posted: May-29-2022 at 8:44pm
|
Had two great days on the water, and as in maneuvering around the dock I lose throttle. Can shift in and out of gear, but only at idle. No amount of throttle at the helm did anything. Pulled open the engine box, disconnected cable from the carb, and pulled out the inner cable two feet before I pushed it back in and closed everything up for the evening. Tomorrow boating is cancelled, but at least we'll play on the lake. So, it's an '87 Martinique. I'm not sure which control is on it, MV2? Any suggestions on how I identify what I need to order? |
Replies:
Posted By: KENO
Date Posted: May-30-2022 at 5:32am
|
Here's a link to a video by skiboatpartsonline on identifying/measuring steering cables and shift/throttle cables. Shift and throttle cables start at about the 10 minute mark http://www.youtube.com/watch?v=WEiCQz0ytLQ" rel="nofollow - link and since it was their video, here's a link to their website page with the right cables, just pick the right length http://skiboatpartsonline.com/Inboard-Ski-Boat-Parts/cables-cable-accessories/" rel="nofollow - link and get some cable ends too.  Lots of places have the cables and ends |
Posted By: CanvasVapor
Date Posted: May-31-2022 at 9:00am
Hi KENO, as always, many sincere thanks for your quick and helpful reply.  Cable snapped at the control end.  17 feet (204 inches) for an '87 Martinique throttle cable. MORSE D32377-003-0204 0, with http://https://www.mavin.com/pdf/Morse%20Controls%20Push%20Pull%20Cable.pdf" rel="nofollow - spec sheet  |