Print Page | Close Window

Installing new exhaust hose

Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50728
Printed Date: January-15-2025 at 7:01pm


Topic: Installing new exhaust hose
Posted By: NeilMcG
Subject: Installing new exhaust hose
Date Posted: July-04-2022 at 10:36pm
Hi everyone,
('78 Nautique)
So I had the hoses attached to the elbow with them double clamped tightly, or so I thought. As I started to push the hose downward to create a bend and meet the mufflers, I had to push so hard that the hose slipped right off, The elbows are powder coated at the end so I wonder if the surface is too slick.
I then tried to create a bend manually outside the boat by holding the ends and pushing against a pole...this produced a nice pancake. As a result, I don't recommend this technique.
Any suggestions on the best way to accomplish this?
Thanks
------------- 
Bellagio Boy


Replies:
Posted By: pjsmoreno
Date Posted: July-05-2022 at 7:33am

I know what you mean when bending these hoses. They are very rigid and don’t cooperate.  I called a friend over to hold one end while I insert into the muffler. Make sure the clamps were extremely tight on the hoses.

Posted By: NeilMcG
Date Posted: July-05-2022 at 5:38pm
Im going to try working aft to front. Read that it may be essier


Print Page | Close Window