1986 Martinique muffler replacement
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50844
Printed Date: January-15-2025 at 3:02pm
Topic: 1986 Martinique muffler replacement
Posted By: norrisdam
Subject: 1986 Martinique muffler replacement
Date Posted: August-17-2022 at 9:12pm
| I need to replace the mufflers on my 1986 Martinique because one of them is leaking water into the bilge. Any info or suggestions on this would be helpful! Thanks |
Replies:
Posted By: NeilMcG
Date Posted: August-27-2022 at 4:34pm
|
It depends on where the leak is coming from. If there is only small fracture in the straight expanded 4" section, then you could wrap with epoxy and fiberglass to seal and it should be fine. However, if it's coming from the end that connects to the hose, then it's more difficult to deal with. The muffler, being fiberglass, along with its age, is likely to be brittle throughout. The fact that you even have a leak coming from a non-load bearing (aside from the internal pressure) component is your evidence of that. I learned this while working on a 78 Nautique. When removing the hose, I used a pry bar to loosen it up and it cracked immediately, It then started disintegrating into pieces as I messed around trying to square it off. Centak makes in-line mufflers, and although not cheap, they don't exactly break the bank either. My prediction is that this is the first of what will be more incidents of the same. .
|
Posted By: Jonny Quest
Date Posted: August-27-2022 at 5:12pm
|
Website for Centek: https://centekmarine.com/solutions/propulsion-wet-exhaust/ ------------- Current 2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
Posted By: norrisdam
Date Posted: August-27-2022 at 5:14pm
|
I repaired this area 3 years ago and it held until recently. It is in the straight section and in the same area. Going to tackle it on Monday. I tried to get a replacement from Nautique Parts but it wasn’t available. I’ll take a look at Centak. Thanks for the info.
|
Posted By: TRBenj
Date Posted: August-29-2022 at 12:21pm
|
I have a used pair as well if you’re interested. |
Posted By: norrisdam
Date Posted: August-29-2022 at 8:30pm
|
What would be the cost without shipping? Where are you located? Thanks
|
Posted By: TRBenj
Date Posted: August-30-2022 at 12:50pm
|
norrisdam wrote: