Transmission install Torque Specs
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: Common Questions
Forum Discription: Visit here first for common questions regarding your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=51395
Printed Date: November-21-2024 at 1:51pm
Topic: Transmission install Torque Specs
Posted By: Oldskier
Subject: Transmission install Torque Specs
Date Posted: October-07-2023 at 9:16am
|
I’m upgrading my 1996 Ski Nautique transmission from PCM 40a to 80a. Ready to install new transmission. Which bolts should be specifically torqued and to what spec? Dampener plate to fly wheel Bell housing to engine Starter to bell housing Transmission to bell housing Transmission mount Swivel lock on mount Coupler ------------- Life is in Session |
Replies:
Posted By: KENO
Date Posted: October-07-2023 at 12:19pm
|
Here's an old thread in the link, with some info http://www.correctcraftfan.com/forum/forum_posts.asp?TID=49191&title=torque-specs-for-pcm-trans-and-vdrive" rel="nofollow - link to some Chevy numbers Otherwise you're looking at bolt sizes, pitch, hardness and torque charts to come up with numbers.............or just using your calibrated elbow and some common sense.  Edit.........Oldskier disregard this, The info above is for a Chevy and in your 96 you most likely have a Ford. More numbers to come for a Ford Here's a new link to an old thread that has some Ford numbers http://www.correctcraftfan.com/forum/forum_posts.asp?TID=49713&PID=595454&title=pcm-80-trans-install#595454" rel="nofollow - link to some Ford numbers |
Posted By: Oldskier
Date Posted: October-07-2023 at 9:38pm
|
Thanks Keno ------------- Life is in Session |