morris hydrolic steering
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=5988
Printed Date: January-17-2025 at 5:56pm
Topic: morris hydrolic steering
Posted By: doug e
Subject: morris hydrolic steering
Date Posted: March-12-2007 at 9:54am
I have an morris hydrolic helm with a bad seal, does anyone know where to get parts for one?? Thanks
-------------
Cheap thrill fishing team
|
Replies:
Posted By: boat dr
Date Posted: March-12-2007 at 10:27am
Doug, is the helm leaking or is it the cyl.
I don't see any parts nor listing for the Morse hyd. steering,Sea star,made by Teleflex /Morse,also Baystar,same Co.
You may have to replace the unit.......boat dr
-------------
boat dr
/diaries/details.asp?ID=4631 - 1949 Dart
/diaries/details.asp?ID=1533 - 1964 American Skier
|
Posted By: 8122pbrainard
Date Posted: March-12-2007 at 11:23am
Doug, If it's just a bad seal, then it may be located through a industrial power transmission supply. If it's a shaft or cylinder, it's probably a standard off the shelf seal and should have a # printed on it. However, a bad seal may be caused by internal wear so go by what the boat dr. says and look into it farther.
-------------
/diaries/details.asp?ID=1622" rel="nofollow -
54 Atom
/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique
64 X55 Dunphy
Keep it original, Pete
<
|
Posted By: doug e
Date Posted: March-12-2007 at 12:56pm
It's the helm seal (the one that pops out), I took the seal to the local marine dist. and nothing he had matched up.
-------------
Cheap thrill fishing team
|
Posted By: 8122pbrainard
Date Posted: March-12-2007 at 1:25pm
Doug, Look in your yellow pages under power tranmission to see whats close to you. This is not the transmision in you car catagory!! It's sprockets,gears,bearings,motors,drive belts,etc. and of coarse seals. Keep in mind that there may be internal wear in the helm that caused the seal to fail. Good luck.
-------------
/diaries/details.asp?ID=1622" rel="nofollow -
54 Atom
/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique
64 X55 Dunphy
Keep it original, Pete
<
|
Posted By: doug e
Date Posted: March-23-2007 at 11:30am
Thanks for the help, a local trans. shop found me a good replacement for it!!!
-------------
Cheap thrill fishing team
|
|