quick question on sanding/polishing hull
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=8233
Printed Date: September-27-2024 at 12:33pm
Topic: quick question on sanding/polishing hull
Posted By: ac505
Subject: quick question on sanding/polishing hull
Date Posted: September-03-2007 at 5:50pm
Once I get the all clear from the doc to actually do anything again, I'm going to tackle the hull which has faded over the years.
My plan is to wet sand using 1000 grade, then apply cutting polish with a rotary mop and finally polish with a random orbit.
Quick question, for the application of the cutting compound should I use a lambswool or sponge bonnet on the rotary mop?
|
Replies:
Posted By: jbear
Date Posted: September-03-2007 at 6:42pm
Al; Hope you are recovering quick.
Do a "search" on the site. Numerous threads about sanding and polishing. Lots of different ideas...enough to confuse I'm sure.
john
-------------
"Loud pipes save lives"
AdamT sez "I'm Canadian and a beaver lover myself"...
|
Posted By: 81nautique
Date Posted: September-03-2007 at 8:42pm
9" double sided lambs wool so you can flip it over when it gets too dirty. Fill a 5 gal pail 1/2 way with water and a little bleach to soak it in overnite, comes out nice and clean and ready to go.
-------------
You can’t change the wind but you can adjust your sails
|
|