Site Sponsors:
Brochures:
1992 Correct Craft Brochure
1993 Correct Craft Brochure
1993 Correct Craft 'Short' Brochure
1994 Paragon
1994 Correct Craft Brochure
Brochures:1992 Correct Craft Brochure
1993 Correct Craft Brochure
1993 Correct Craft 'Short' Brochure
1994 Paragon
1994 Correct Craft Brochure
Diaries | Details
This boat's story has been posted by the owner. Please contact the owner with any questions. You may use the form below to send the owner an email.
Updated:
7/16/2013 (12 years ago)
Originally Posted: 12/16/2012
Total Views: 792
Owner: Wes Garrison
Forum Nickname: Wes1089
Location: New Egypt, NJ
Model: 1993 Sport Nautique
Length: 21
Engine: Ford PCM 351
HP: 280
Hours: 550
Modify this Diaries Listing
Forum Nickname: Wes1089
Location: New Egypt, NJ
Model: 1993 Sport Nautique
Length: 21
Engine: Ford PCM 351
HP: 280
Hours: 550
Modify this Diaries Listing
The family is loving our first season with the Sport Nautique.
Purchased the boat Oct, 2012
Projects Completed:
- refinished Swim Platform
- replaced leaking tranny cooler
- new Bluetooth enabled stereo
- Installed Faria Depth w/ air & water temp in clock hole
- repack stuffing box
- standard pre-season stuff (change oil, change trans fluid, impeller, spark plugs, check timing
- stop-gap refinish of trailer paint
- new carpet on trailer bunks and new bow stops
- new trailer break actuator
- spare tire holder
Projects on the list
- Gel coat patch three spots
- Buff exterior (wet sand if needed)
- install manufacturer stickers
- clean-up gauge wires and run new ground wire (tach seems low, gas gauge is jumpy)
- replace temp gauge with VDO
- bimini top
Purchased the boat Oct, 2012
Projects Completed:
- refinished Swim Platform
- replaced leaking tranny cooler
- new Bluetooth enabled stereo
- Installed Faria Depth w/ air & water temp in clock hole
- repack stuffing box
- standard pre-season stuff (change oil, change trans fluid, impeller, spark plugs, check timing
- stop-gap refinish of trailer paint
- new carpet on trailer bunks and new bow stops
- new trailer break actuator
- spare tire holder
Projects on the list
- Gel coat patch three spots
- Buff exterior (wet sand if needed)
- install manufacturer stickers
- clean-up gauge wires and run new ground wire (tach seems low, gas gauge is jumpy)
- replace temp gauge with VDO
- bimini top
