my Timmy T |
Post Reply | Page <12 |
Author | |
gt40KS
Gold Member Joined: August-05-2017 Location: Wichita Kansas Status: Offline Points: 943 |
Post Options
Thanks(0)
|
YUK, Pete ... Wow. I'd get bottled water.
Having said that, the strainers we use don't filter down to the micron level anyway - a .07" particle will pass right through. I'd say all that Yuk is headed through the engine one way or another. But yes, I am doing all new plumbing, flushing T and a new strainer after I get the engine in and I will be installing the T before the strainer... just because |
|
JCCI
1995 Ski Nautique GT40 |
|
gun-driver
Grand Poobah Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4112 |
Post Options
Thanks(0)
|
That's why I put this on my shower.
And I go with the simple bucket |
|
nhhandyman
Newbie Joined: August-24-2017 Location: Maine/NH Status: Offline Points: 28 |
Post Options
Thanks(0)
|
Thanks for all the replies - I'll post a pic next time I get to the boat.
I also went for the 1"x3/4"x1" Tee - not the 1x1/2x1 listed above. |
|
WinterTurtle
Groupie Joined: July-18-2017 Location: Summerfield, NC Status: Offline Points: 79 |
Post Options
Thanks(0)
|
Does the tee need to be installed between the rwp and the trans heat exchanger - or between the inlet and the heat exchanger? I don't have a strainer (yet)...
|
|
1979 Southwind 18 351w
Not Running - All Potential! |
|
nhhandyman
Newbie Joined: August-24-2017 Location: Maine/NH Status: Offline Points: 28 |
Post Options
Thanks(0)
|
Here is mine - installed yesterday - will be trying it out at some point this week.
And yes, I will be getting a plug just in case that ball valve chooses to open up... |
|
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21125 |
Post Options
Thanks(0)
|
No plug necessary.
You’re going to have a hard time priming the pump with that location. |
|
nhhandyman
Newbie Joined: August-24-2017 Location: Maine/NH Status: Offline Points: 28 |
Post Options
Thanks(0)
|
priming the pump....
why... because the water will be heading out the inlet before getting sucked in? |
|
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21125 |
Post Options
Thanks(0)
|
Correct, only an issue if the pump isn’t already primed. |
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |