PARTS SOURCE NEEDED |
Post Reply |
Author | |
Lakeview
Senior Member Joined: January-06-2004 Location: Branchville NJ Status: Offline Points: 247 |
Post Options
Thanks(0)
Posted: June-17-2017 at 5:22pm |
Bell housing to transmission double ended studs 3 3/4 " overall length x 14 thread both ends-my local NAPA store tried Dorman and ARP with no luck
|
|
Lakeview
1992 Barefoot Nautique 1967 Barracuda SS 1967 Chris Craft Cavalier |
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10653 |
Post Options
Thanks(0)
|
I seem to remember getting some at ebasicpower but it took a phone call to find them.
|
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10653 |
Post Options
Thanks(0)
|
Here's the PCM part number for the transmission studs R031005
|
|
DayTony
Gold Member Joined: June-30-2013 Location: Salem MA Status: Offline Points: 830 |
Post Options
Thanks(0)
|
Mcmastercarr.
|
|
1988 Barefoot nautique-454
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
|
+1 |
|
Lakeview
Senior Member Joined: January-06-2004 Location: Branchville NJ Status: Offline Points: 247 |
Post Options
Thanks(0)
|
McMaster Carr only goes to 2 1/2 " length according to their online chart-Thanks Ken for the PCM # will call Ski dim tomorrow.
|
|
Lakeview
1992 Barefoot Nautique 1967 Barracuda SS 1967 Chris Craft Cavalier |
|
Lakeview
Senior Member Joined: January-06-2004 Location: Branchville NJ Status: Offline Points: 247 |
Post Options
Thanks(0)
|
Thanks Ken-Part # still good-once again SKIDIM comes thru-
How is your Quick Fuel Carb performing?? |
|
Lakeview
1992 Barefoot Nautique 1967 Barracuda SS 1967 Chris Craft Cavalier |
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10653 |
Post Options
Thanks(0)
|
Glad they had them, I seem to remember being surprised by the price being pretty reasonable too. At least it was a few years back.
I have a Quick Fuel sitting on the shelf that was used, needed rebuilding and it ran real well afterwards. It'll replace a Holley at some point but the Holley is working just as well right now. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |