Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Engine Problems
  FAQ FAQ  Forum Search   Register Register  Login Login

Engine Problems

 Post Reply Post Reply   
Author
Marauder71 View Drop Down
Newbie
Newbie
Avatar

Joined: November-24-2009
Location: Louisiana
Status: Offline
Points: 37
Post Options Post Options   Thanks (0) Thanks(0)   Quote Marauder71 Quote  Post ReplyReply Direct Link To This Post Topic: Engine Problems
    Posted: November-30-2009 at 1:54pm
Peter,

I am about 3.5 hours away from Billy.
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: November-30-2009 at 1:36pm
David,
When you shut down the engine, check for gas dribbling down the throat of the carb. It may be time for a carb rebuild. Also, if the boat has set for some time and you are now running ethanol gas, it could be dissolving junk in the tank/fuel system.

How close are you to Billy (Boat dr)?


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
Marauder71 View Drop Down
Newbie
Newbie
Avatar

Joined: November-24-2009
Location: Louisiana
Status: Offline
Points: 37
Post Options Post Options   Thanks (0) Thanks(0)   Quote Marauder71 Quote  Post ReplyReply Direct Link To This Post Posted: November-30-2009 at 1:23pm
Well we went for our maiden voyage yesterday and all went pretty well until the end. We took her on two runs and she did good on both. Her whole shoot was decent and she didn't seem to have too much vibration through out the rpm range, I think the prop needs to be reworked to smooth everything out. After we completed the second run the boat sat for 15 mins before we got ready to take her to the boat launch. After that every time I put her in gear she would die. If I got her in gear and quickly gave her gas, either ahead or astern, she would run fine but would immediately die going back into clutch(dead slow). I figuring I need to check the fuel line and replace the filter to start and then maybe a carb adjustment after that. Has anyone had a similar problem? Any suggestions on where to start?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC